How to Move a Hot Tub or Spa Safely
Published by Professional Moving Solutions · Updated

To move a hot tub, have a licensed electrician disconnect the power, drain and dry the tub completely, measure every gate and turn on the path, then tip it onto a hot tub dolly with a trained crew, strap it on a truck and set it on a level, solid pad. The lift is only half the job. Most failed hot tub moves go wrong on planning, access and the pad, not on muscle.
This guide walks through each step in order, explains what equipment is used, covers what affects the cost and shows where a professional crew earns its fee. If you would rather hand the whole thing off, see our hot tub and spa moving service or request a price on the quote form.
How heavy is a hot tub, and why does that matter?
Hot tubs are heavier than they look even with no water inside. The shell, the frame, the cabinet, the pumps and the heater add up, and larger multi-person spas weigh much more than small two-seat models. Check your owner's manual or the manufacturer's spec sheet for the dry weight of your exact model before you plan anything.
Weight matters for three reasons:
- It decides how many people and what equipment the move needs.
- It decides whether the route can be done on a dolly or needs lifting equipment.
- It decides what the new pad or deck must be able to carry once the tub is filled.
What should you do before moving a hot tub?
Step 1: Measure the tub and walk the route
The path is usually the hardest part. A hot tub moves on its side, so the height of the tub becomes the width you need through gates and side yards. Walk the route with a tape measure at both addresses.
- Measure the length, width and height of the tub, including the cabinet, steps and any raised features.
- Measure every gate, side path and doorway between the tub and where the truck can park.
- Note slopes, steps, soft ground, gravel and anything that would stop a wheeled dolly.
- Look up: overhead lines, tree limbs, gutters and roof overhangs.
- Note fences or sections that may have to come down temporarily.
- Do the same at the new location, all the way to the pad.
Take photos as you go. Photos of the tub, the path and the new spot are the single best thing you can send hot tub movers for an accurate quote.
Step 2: Have a licensed electrician disconnect the power
Most hot tubs run on a dedicated, high-power circuit. Have a licensed electrician switch off the breaker, disconnect the supply at the disconnect box and cap the wiring before moving day. Do not do this yourself. Moving crews, including ours, do not do electrical work, and you will need the electrician again to reconnect the tub at the new home.
Step 3: Drain, clean and dry the tub
Drain the tub fully at least a day ahead. Clean the shell, open the drain valves and let the lines empty as much as possible, then dry the interior. Remove the filters and any loose parts, bag them and keep them with the cover. In cold weather, getting the water out of the plumbing is especially important. Your manufacturer's guide or a spa technician can walk you through your model.
Step 4: Remove and protect the cover and accessories
Take off the cover, cover lifter, steps and any surround panels. Move them separately. Never lift or strap a hot tub by its cover or its rim. Remove anything on the cabinet that could snag on a gate.
What equipment do you need to move a hot tub?
A hot tub dolly or skid
The tub is tipped onto its side and set on a purpose-built spa dolly or skid board. This keeps the shell supported along its frame and keeps pressure off the cabinet walls and the jets. A furniture dolly or a hand truck is not designed for the shape or the weight.
Padding, straps and a suitable truck
The cabinet is padded or blanket wrapped so it does not scrape on gates or the truck. On the truck, the tub is strapped down so it cannot shift or tip. The truck needs enough deck length and a safe way to load: a liftgate, ramp or trailer suited to the weight.
Lifting equipment and extra hands
A tub going over a fence, up onto a raised deck, down a steep slope or into a backyard with no side access may need lifting equipment or additional crew. A good mover asks about this when quoting, so it is planned before the day instead of discovered at the curb.
How do you set up a hot tub at the new location?
Step 5: Prepare a proper pad or deck
The tub needs a level, solid surface that can carry the weight of the tub plus water and people, such as a concrete pad or a properly engineered deck. An uneven or soft base can strain the shell and plumbing over time. Have the pad ready and cured before moving day so the crew can set the tub once and leave.
Step 6: Place, level and reconnect
The crew rolls the tub to the pad, tips it upright and positions it with the equipment access panel where your electrician and technician can reach it. After placement, a licensed electrician reconnects the power and a spa technician checks the plumbing and fittings before you refill.
If there is a gap between homes, or the new pad is not ready, we can hold the tub at our commercial warehouse in Richmond, VA. Tell us how long you need when you ask for a quote. See our warehousing page for details.
Is it safe to move a hot tub yourself?
People try it with friends and a borrowed trailer. Here is why it often goes wrong:
- Weight and balance. A tub on its side is top-heavy and shifts as it rolls, so a small slip becomes a serious injury.
- Hidden damage. Cracked shells, broken cabinet panels and plumbing leaks often do not show up until the tub is refilled.
- Access. A tub that does not clear a gate or a turn gets stuck, scraped or dropped.
- Equipment. Ratchet straps and a utility trailer do not replace a spa dolly, padding and a trained crew.
- Property damage. Lawns, pavers, fences, decks and siding all take the hits.
Our crews arrive with the right equipment, are background-checked and drug-screened, and work with an on-site supervisor. The unit is blanket wrapped before it moves and handled the same way we handle a piano, a gym machine or a commercial appliance.
How much do hot tub movers cost?
There is no honest flat price for moving a hot tub, because the details change the work. What drives the cost:
- Size and weight of the tub.
- Access at both ends: gates, slopes, stairs, decks and how far the crew carries it.
- Distance between addresses, local or long distance.
- Whether lifting equipment or extra crew is needed.
- Storage between homes, if you need it.
- The date, including weekends and peak moving season.
Movers who ask detailed questions about your route are the ones who price it right. A rock-bottom number that does not ask about the gate is a sign of an extra charge on moving day.
Where can I find hot tub movers near me?
We move hot tubs and spas in Richmond, Hampton Roads, Washington DC, Baltimore, central New Jersey and Houston, and nationwide through our partner network. See our service areas page for the full list. The same crews handle other heavy, awkward items, so if you are also moving a piano, gym equipment or large appliances, it can go on the same quote.
Related reading: how much piano movers cost, how to ship gym equipment and what white glove delivery includes. For the bigger picture on how we handle heavy items from the truck to the spot you choose, see our white glove delivery and last mile delivery pages.
Frequently asked questions
See more deliveries like this on our Facebook page (opens in a new tab)
How do you move a hot tub?
Have a licensed electrician disconnect the power, drain and dry the tub, remove the cover and loose parts, measure the full path, then use a hot tub dolly or skid and enough trained people to tip the tub on its side, roll it to the truck, strap it down and set it on a level pad at the new location.
How much does it cost to move a hot tub?
It depends on the size and weight of the tub, how easy the access is at both addresses, the distance, whether lifting equipment or extra crew is needed and the date. Photos of the tub and the path let a mover give you an accurate quote.
Can I move a hot tub myself?
It is possible but risky. Even drained, a hot tub is heavy, top-heavy on its side and easy to crack or scrape. Without a proper dolly, padding and a trained crew, people commonly get hurt or damage the shell, cabinet, plumbing or their property.
Do hot tub movers disconnect the electrical?
Professional Moving Solutions does not do electrical or plumbing work. A licensed electrician should disconnect the power before the move and reconnect it at the new location, and a spa technician should handle any plumbing.
How long should a hot tub drain before moving?
Drain it fully at least a day before the move, then open the drain valves, remove the filters and dry the shell so no water is left in the lines. Water left inside adds weight and can leak or freeze in transit.
Can you store a hot tub between homes?
Yes. If the new pad is not ready or there is a gap between closing dates, we can store the tub at our commercial warehouse in Richmond, VA. Tell us how long when you request a quote.